How to mount the sensors

There are a few ways to mount the sensors to your pool’s plumbing. There may be more but here are a few options.

Support collars and sensor holders

This is the traditional method and will allow you to place the sensors at different places along the plumbing.

The Zelia Pod analysis chamber

This analysis chamber allows you to to place both pH and ORP/Redox probes and both injectors in one easy package. If you use this chamber, we recommend that you vary the sensor depth slightly so as to make sure they don’t interfere with each other.

The classic analysis chamber

This analysis chamber creates a derivation from the plumbing so the water is tested in a calmer state. It allows you to place both the pH and ORP probes, one in each chamber or one of them and a temperature sensor.

The 3 outlet analysis chamber

This one will hold both pH and ORP Probe and the temperature sensor in one place. If you use this one, we recommend putting the temperature sensor in the middle and using staggered depth for the ORP and pH sensor to ensure they don’t interfere with each other.

Whichever solution you choose wil determine where you install it on your plumbing and that is completely dependent on how it was set up. If you wish some advice on the best solution, feel free to email us with a picture of your setup so we can help guide you.

All those installation solutions are commonly avaliable online and we have no affiliation with any of them or any reseller.